<![CDATA[Proto Module could be more useful]]>The PROTO module is kind of an poor design. It is just a perf board. It would have been more useful to at bring out the header pins to solder points on the PCB. The way it is now you have to solder wire to the SMT pad under the header. Makes no sense. Also, bring out the 3.3, 5V, and GND to busses so they can be used. I am just going to make my own proto module. I finally managed to locate the Samtec header part number but they take a few weeks to get.

]]>https://community.m5stack.com/topic/204/proto-module-could-be-more-usefulRSS for NodeWed, 29 Apr 2026 01:32:23 GMTFri, 04 May 2018 12:32:02 GMT60<![CDATA[Reply to Proto Module could be more useful on Mon, 01 Feb 2021 22:33:38 GMT]]>Fully agree on this one.
Having access to the bus signal would be a minimum.

]]>https://community.m5stack.com/post/12262https://community.m5stack.com/post/12262Mon, 01 Feb 2021 22:33:38 GMT<![CDATA[Reply to Proto Module could be more useful on Sat, 05 May 2018 13:56:55 GMT]]>This might be helpful to you.

custom-prototype-board

]]>https://community.m5stack.com/post/952https://community.m5stack.com/post/952Sat, 05 May 2018 13:56:55 GMT<![CDATA[Reply to Proto Module could be more useful on Fri, 04 May 2018 18:25:04 GMT]]>Could you share the Samtec header part number and the seller's link ?

]]>https://community.m5stack.com/post/950https://community.m5stack.com/post/950Fri, 04 May 2018 18:25:04 GMT