<![CDATA[uiflow firmware issues with stickC]]>I am trying to install stickC 1.2.3 uiflow firmware on stickC and I get the following error -
A fatal error occurred: Timed out waiting for packet header
I can upload code to this stickC board using arduino just fine. I also tried the 1.3.0 firmware but I get the same error. Also is the 1.3.0 beta only for m5stack.

]]>https://community.m5stack.com/topic/971/uiflow-firmware-issues-with-stickcRSS for NodeMon, 04 May 2026 13:15:09 GMTWed, 01 May 2019 07:54:12 GMT60<![CDATA[Reply to uiflow firmware issues with stickC on Sun, 05 May 2019 10:37:05 GMT]]>0_1557052620267_微信截图_20190505183628.png

]]>https://community.m5stack.com/post/4136https://community.m5stack.com/post/4136Sun, 05 May 2019 10:37:05 GMT<![CDATA[Reply to uiflow firmware issues with stickC on Sun, 05 May 2019 10:36:50 GMT]]>@jpilarski What's the serial port name after you attached M5StickC to PC?
![0_1557052605845_微信截图_20190505183628.png](正在上传 100%)

]]>https://community.m5stack.com/post/4135https://community.m5stack.com/post/4135Sun, 05 May 2019 10:36:50 GMT<![CDATA[Reply to uiflow firmware issues with stickC on Wed, 01 May 2019 11:22:49 GMT]]>@jpilarski check the port address of the m5stickc in Arduino you can select the port but in m5burner it is still hard coded to cu_slabUSBtoUART which my stick doesn’t connect as.

]]>https://community.m5stack.com/post/4084https://community.m5stack.com/post/4084Wed, 01 May 2019 11:22:49 GMT