Wiring of M5Stack Mini Infrared Emitter & Receiver Unit
-
Dear all,
I bought the M5Stack Mini Infrared Emitter & Receiver Unit.
Now I attached it to the M5stack Atom Lite. According to the sticker, I would assume that one needs to connect the "white" line with the TX port and the "yellow" line with the RX line, see the image.
For some reason I do not understand, I have to switch the TX and RX lines to get the device working. Can somebody confirm?
I also post the question here.
Thanks and best wishes,
Tobias -
Yes, you have to "switch" the lines between the IR Unit and the Atom :
One side is Tx -> RX, the other side RX -> TX-
White line: IR Unit receives the signal and transmitts it(TX, marked "data" IN) ) to the Atom,. Atom is receiver (RX), (G32 as input)
-
Yellow line: Atom is the sender (TX) (G26 as output), IR Unit receives the data (RX) (marked "data" OUT) and transmitts the signal via IR (25Hz carrier) Check if it works with a mobile phone camera ...
-
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login