M5Tough - RS-485 in Uiflow2

[robski]

Hi,
Is build in RS-485 in to M5Tough controller supported in uiflow2?
Can't see it in Hardware options. No Modbus blocks like when RS-485 module/unit added.

[felmue]

Hello @robski

you can use the blocks of the Modbus unit (with modified TX/RX pins) to control the internal Modbus interface.

Please see Project Zone example M5Tough_Internal_Modbus_ACSSR_UIFlow2.0.3.

Edit: corrected Play Zone to Project Zone, sorry about that.

Thanks
Felix

[robski]

@felmue said in M5Tough - RS-485 in Uiflow2:

Hello @robski

you can use the blocks of the Modbus unit (with modified TX/RX pins) to control the internal Modbus interface.

Please see Play Zone example M5Tough_Internal_Modbus_ACSSR_UIFlow2.0.3.

Thanks
Felix

Ok, understand, add "virtual unit" and reconfigure pins for internal extension, thx.

[Raed.Alnuaimi]

Hello @felmue
I am having the same problem, and can not locate the Play Zone example M5Tough_Internal_Modbus_ACSSR_UIFlow2.0.3.
Can you please send the link to that???
Thanks

[felmue]

Hello @Raed-Alnuaimi

the example is in the Project Zone (by mistake I wrote Play Zone, sorry about that). Fixed in my post.

Thanks
Felix

[Raed.Alnuaimi]

@felmue
Thank you for the prompt response, I will try it today