Using PlatformIO (VS Code) with Tab5
-
Has anyone used VS Code/PlatformIO to successfully program the new Tab5? If yes, how to configure the board in platformio.ini?
-
[env:esp32p4_pioarduino] platform = https://github.com/pioarduino/platform-espressif32.git#54.03.20 upload_speed = 1500000 monitor_speed = 115200 build_type = debug framework = arduino board = esp32-p4-evboard board_build.mcu = esp32p4 board_build.flash_mode = qio build_flags = -DBOARD_HAS_PSRAM -DCORE_DEBUG_LEVEL=5 -DARDUINO_USB_CDC_ON_BOOT=1 -DARDUINO_USB_MODE=1 lib_deps = https://github.com/M5Stack/M5Unified.git https://github.com/M5Stack/M5GFX.git -
@kuriko It worked perfectly! Thank you very much!
-
@RonaldoDuarte said in Using PlatformIO (VS Code) with Tab5:
@kuriko It worked perfectly! Thank you very much!
Thanks for confirming it works, RonaldoDuarte. I was just about to try the same setup on the Tab5, good to know this config runs without issues. Let me know if you run into anything else during your development.
Ask ChatGPT
-
@kuriko Thank for this information, my question is wich board type are you choose in PlatformIO
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login