How to stop the state information output to the serial port 0?
-
I want to control UART device through serial 0 of the M5stack.
But M5stack output string (status information?) to the serial 0 at the timing of power on and reset. This string cause error of the UART device. So I want to stop this output. The string is like following.
ets Jun 8 2016 00:22:57
rst:0x1 (POWERON_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0018,len:4
load:0x3fff001c,len:1100
load:0x40078000,len:9232
load:0x40080400,len:6400
entry 0x400806a8
M5Stack initializing...OK
Even if the program is just only initializing process, the string is output. I am very confusing that. How can I stop it?
#include <M5Stack.h>
//HardwareSerial Myserial(0);void setup() {
// put your setup code here, to run once:
M5.begin(true, false, true);
serial.begin(115200);
}void loop() {
// put your main code here, to run repeatedly:
delay (100);
}
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login