m5stickc plus 2 wiring
-
i have m5stickc with ports gnd,5v out,g26,g36,g0,bat,3v3,5v in,gnd,5v out,g32,g33 i want to connect on multiple stuff. how to connect 2.8tft spi 240x320 v1.2 pins:t_irq,t_do,t_din,t_cs,t_clk,sdo(miso),led,sck,sdi(mosi),dc,reset,cs,gnd,vcc ir transmitter:gnd,vcc,dat ir receiver:out,vcc,gnd rfid-rc522:sda,sck,mosi,miso,irq,gnd,rst,3.3v sd card:3v3,cs,mosi,clk,miso,gnd everything will be connected to Prototype Board so how to connect everyhting on to work normally. i will have beside charger for battery and holder for 2 batterys 3.7v
for too less gpio pins i have MCP23017 I2C Interface 16bit I/O Extension Module Pin Board IIC to GIPO Converter 25mA1 Drive Power Supply for Arduino and C51.
Thanks for help because im new to electronics and i dont have much knowladge about that.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login