Port "E", Port "Custom" and Pogo
-
Hi all,
Port "E", where can I find it?
Port "Custom", these are pins from the bus, right?
Pogo pins, they are only for charging, right - using them as interface is not possible?
Sorry for these question, but due to my experience regarding docu - its poor - the available docu ;-)
KR,
Uli -
Port "Custom" is used for defining pins that are not set as the default port A B and C.
For example, if you wanted to connect an 2nd unit to a stickC you would chose the custom and then set the tx and rx pins to two of the pins from the hat connector.
As to port E well, I'm yet to find out. -
@uli said in Port "E", Port "Custom" and Pogo:
Pogo pins, they are only for charging, right - using them as interface is not possible?
According to the product page, the pogo pins can also be used for I2C (GPIO 21 and 22) on supported devices (BALA)
https://docs.m5stack.com/#/en/base/m5go_bottom?id=pinmap
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login