[Product Revision] Tube/Air Pressure Unit with I2C

[Saiyande]

Tube/Air Pressure Unit (U130) with I2C output instead of analog (I2C Sensor or I2C ADC)

[Maethaxi]

Adafruit makes one: https://www.adafruit.com/product/3965
SparkFun also makes one: https://www.sparkfun.com/products/16476

[teastain]

@maethaxi Good info!

The Adafruit must be an older design, as the I2C pins are not in the Grove signal order and would require cutting the end from a Grove cable and crossing wires and soldering!

The Sparkfun unit is 'micro-grove' JST 1.0mm but wired correctly for grove. You would need a JST 2.0 (Grove) to JST 1.0 (qwiic) adapter cable. Mine is homemade but opens up another world of sensors to my faithful M5Stack equipment!
added:
Sparkfun qwiic to Grove converter cable
https://www.sparkfun.com/products/15109

[Maethaxi]

@teastain
Thanks for pointing out what the connectors are for M5Stack & SparkFun. I usually use "Grove2Dupont Conversion Cable 20cm (5Pairs)" (SKU: A096) for adapting stuff to grove. I'll add some JST PH (2.0) & JST SH (1.0) to my next components order.
You're right, definitely opens up a whole new world of accessories!

[Zavyru]

@Maethaxi Adafruit has them as well: https://www.adafruit.com/product/4424

[Maecksu]

There's a similar request here:
https://community.m5stack.com/topic/5241/new-module-sdp3x-differential-pressure-sensor

[Kenzo]

@Maethaxi Thanks I was looking for a Tube/Air Pressure unit with a I2C interface... I was trying to use the M5Stack Tube/Air Pressure Unit but I am running into an issue so I figured I would look for other options if I can't get it to work accurately... I need a sensor sensitive enough to detect someone blowing lightly in a tube....