M5 Stamp C3 -> Which Flash Mode to choose in Arduino IDE
-
Hey mates,
can someone point me out which Flash Mode i should use for the M5 Stamp C3 in Arduino IDE?
QIO, DIO, QOUT or DOUTany help would be great !!
Thx & cheers.....
-
@Knobsi Hi, your question is already two years old. I guess you'll have found the answer, however I just came across it today. I want to share with you an experience I had yesterday:
Suddenly I encountered a problem after upgrading the Arduino IDE from v2.3.4 to v2.3.5.
The board that I use is an M5 Atom Echo which has an ESP32-PICO processor.
After compiling and building a sketch, that compiled, built, and ran OK with v2.3.4,
It crashed after compiling and building and running with v2.3.5.In the crash report I saw "DIO".
In Arduino v2.3.5 I checked the setting: > Tools > Flash Mode.
I saw that the Flash Mode was set for: "QIO".
After I changed the setting Flash Mode it to DIO, re-compiling and building, the sketch ran OK.Regards,
@Paulskpt
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login