Offline
Hi, Had "my" StackChan delivered last friday, nice piece of kit, initially I could not login to app with my M5Stack account then had to try with new account (my son's) and went straight in. Can't wait to play with it ...when my son is at school - it was his late birthday gift from me...
@GiovanniCaenazzo
disconnect M5Dial
press and hold boot button at the back ofM5Dial - in the middle of Stamp Controller - it is very gentle switch
connect M5Dial to USB
M5Burner should detect com port in boot mode
@marryjoseph22 what M5Stack hardware do you have to play with?
@marryjoseph22 if you want to try Arduino way..i can recommend YT and VolosR approach to M5Stack devices, his UI design is top notch
for beginners uiflow blockly is good start and it can switch easly to micropython in same window
@Marcy72317 is there any messages on com port monitor in M5Burner you see on this device?
@Marcy72317 easyloader demo from m5 stack docs page for m5stickC +2
@Marcy72317 have you tried easyloader from m5stickC+2 docs page?
@himlol is comport detected in M5Burner?
do "erase all" option then pick up correct firmware M5StickC, M5StickC+, M5StickC+2
@GusBel use M5Burner and load fresh firmware
@flyingjeepman on/off button on? is M5Burner detecting com port when usb is connected?
@l-roca what happens if you do intensity conversion outside set brightness block then use this variable for set brightness to .... block
other words does set brightness to 25, 50, 75 works fine with fixed values in it?
@JohnSal flashlight code inside function, function in the loop?
@aaapl have you tried pps set to say 25?
@aaapl and module dip switches are set to?
@Morle
not sure but i see 2 diff versions here what is burned to what is running on your machine locally
is all fine with uiflow 2 online version?
@MitchBuckanon M5Dial has 2 external ports PortA and PortB
PortA -> G15/G13/V/G
PortB ->G/V/G2/G1
Pins G15/G13/G2/G1 are programmable so can be used (reconfigured) to be SPI pins SCLK, MOSI, MISO and CS - needed to connect - communicate with - external device like Lan Module
if its about initial config with stock firmware to add your Cardputer device to your wifi then it can be done via M5Burner in config,
@PPKOVY it happens only when relay is called to be on? or on "standby" too?
is your unit 4relay supplied from external voltage source?
